Black Swan's Jumbo Flange & Gasket with Urethane and Brass Bolt Kit is a gasket made of a tough, flexible and durable urethane foam. This urethane gasket is then impregnated with wax. The combination of urethane foam and the wax makes for a stronger, more resilient ring than regular rings and is guaranteed for 10 years. This wax ring is also a jumbo ring. It contains 40% more wax than regular rings. The gasket forms a water tight, gas tight and odor tight seal. Fits 3" and 4" waste lines. Meets Federal Specification TT-P-1536A. This ring has a plastic flange which extends the discharge opening. This makes for a more positive seal and assures proper bowl alignment.
The Black Swan Jumbo Flange & Gasket with Urethane and Brass Bolt Kit is the ideal wax ring kit to use when the floor is a little higher than the existing flange for the toilet. You are getting extra wax and a stronger wax which will be needed to make a good seal in this "uneven" floor situation. Also, you are getting extra long closet bolts. Stock No. 04530 contains two1/4" X 3-1/2" brass bolts, two brass plated nuts, two brass plated washers and two plastic stand-up washers. Stock No. 04531 which contains two 1/4" X 3-1/2 brass bolts, four brass plated nuts and four brass plated washers.
- Be sure the wax ring is at room temperature (about 70° F). If wax ring is too cold a good seal may not be made or the toilet bowl could crack while making the installation.
- With the toilet bowl upside down on a protective pad or blanket, place the wax ring around the discharge opening. Press firmly to assure adhesion when the toilet is inverted.
- Using the Black Swan's Stainless or Stay Soft Putty, make a putty ring about 1 inch high around the outside rim of the toilet. This will make a seal between the toilet rim and the floor.
- Carefully set the toilet down on bolts and twist bowl slightly to spread wax and putty to make a tight seal. Tighten bolts carefully to prevent breaking the bowl.
GHS LABEL INFORMATION
SIGNAL WORD: None
HAZARDOUS STATEMENT: None
Skin: First aid is not normally required. Wash affected area thoroughly with waterless cleaner and/or soap and water. If irritation persists, consult a physician.
Eyes: Firs aid is not normally required. Flush with large amounts of water for 15 minutes, holding eyelids open. Consult a physician if irritation persists.
Ingestion: First aid is not normally required. If swallowed, give two glasses of water to drink. Never give anything by mouth to an unconscious person. Do not induce vomiting. Consult a physician.
Store away from flame, heat (110° F maximum to keep wax rings from melting or deforming in shape) and strong oxidizing agents. Do not stack cases more than seven high on each pallet. .
Dispose of container in accordance with federal, state or local regulations.